Text size
  
   
The global assembly journal for SMT and advanced packaging professionals




iPad Application

Global SMT & Packaging Advertising

Americas
Sandy Daneau
sdaneau@globalsmt.net
Tel: 239-234-1600

Europe
Trevor Galbraith
tgalbraith@globalsmt.net
Tel: +1 (239) 287 5401


SE Asia
Debasish Choudhury
dchoudhury@trafalgarmedia.com
Tel: +91-9811710191

China
Paul Chen
Office: +86 2154049130
pchen@trafalgarmedia.com

Korea
Keon Chang
Young Media Inc.
ymedia@ymedia.co.kr
Tel: +82 2 2273 4833

Subscriptions
subscriptions@globalsmt.net
Tel: +1 (239) 245-9264 x106

Editorial
editor@globalsmt.net
Tel: +1 (239) 245-9264 x101

Email ad materials to ads@globalsmt.net

New Tutorial released with IPC-2223C provides expert advice and tips for designers working with flexible circuits

The industry standard that establishes the specific requirements for the design of flexible and rigid –flexible printed boards, IPC-2223, Sectional Design Standard for Flexible Printed Boards, has been recently updated to its C revision. The standard now includes new design guidance and requirements for preformed bends, irregular folds and creases, staggered flexible layer bands as an alternative to “bookbinder” designs, and depanelization methods for flexible and rigid-flex array sub-pallets, as well as information on the use of adhesiveless materials. Most significant, IPC-2223C includes, as Appendix A, a new design tutorial with guidance on material selection, size and shape of flex circuits and fabrication allowances.

According to Mark Finstad, senior applications engineer with Flexible Circuit Technologies, Inc., and vice chair of the IPC D-11 Flexible Circuits Design Subcommittee that developed the standard, the new tutorial makes the standard easier to understand for designers who do not work with flexible circuits every day. “Very few users get deeply immersed in flex. It takes five to seven years working with it every day before you understand all the aspects of flexible circuit designs.”     

The new version of the standard has been updated to address technology that has matured in the years since the last revision. IPC-2223C includes plenty of information on adhesiveless materials, which weren’t included in earlier documents. As adhesive quality has improved, many manufacturers have moved away from substrates with adhesives.

“We tried to emphasize adhesiveless materials,” said William Ortloff, engineering fellow at Raytheon Company, and chair of the D-11 subcommittee. “Adhesiveless materials are better for soldering; they don’t have the lower temperature requirements common to adhesive based substrates, which can cause problems with glues.”

While the standard has new sections, its size was kept down by avoiding redundancy and focusing only on aspects that are distinctly tied to flexible circuitry. Technologies such as blind, buried and microvias that are the same in flex and rigid printed boards, are not included in IPC-2223C. Instead, users are referred to other standards such as IPC-2221 and IPC-2222 that address these technologies.

However, one aspect of rigid printed board technology that is included in the standard is the connection between rigid and flex printed boards. As Ortloff describes, making this connection correctly is a key point for reliability. “The document explains that you shouldn’t run the adhesive coated coverlays of the flex portion through the rigid printed board; you want to keep the flex adhesive away from vias and plated through-holes (PTH) to increase the reliability of the vias and PTH.”

Finstad adds that IPC-2223C also includes sections on strain relief fillets applied at the rigid-flex interface and other factors that are unique to printed boards that have as many mechanical factors as electrical design points. “It’s always difficult to get the best of both worlds. Flex boards aren’t much good if they can’t bend.”

www.ipc.org/2223www.IPC.org

Add comment


Security code
Refresh

Your Account






Forgot login? Click here.
No account yet? Subscribe